Sensors for monitoring goCoax MoCA adapters and the associated mesh networks.
| Manufacturer | Model | MoCA Speed | Ethernet Port | Supported | Known Working Firmware |
|---|---|---|---|---|---|
| goCoax | MA2500D | 2.5 | 2.5 GbE | YES | 2.0.11 |
| goCoax | MA2500C | 2.5 | 2.5 GbE | YES | 3.0.5 |
| goCoax | WF-803M | 2.5 | 1.0 GbE | YES | 1.0.12 |
| Frontier | FCA252 | 2.5 | 1.0 GbE | YES | |
| Frontier | WF-803T / FCA251 | 2.5 | 1.0 GbE | YES |
NOTE: To ensure sensor data is properly read from the adapters, it is recommended that you update to the LATEST FIRMWARE offered by goCoax Support, or one of the firmwares listed in the above table. However, upgrading firmware MAY reset settings on the adapter.
Make sure Home Assistant Community Store (HACS) is installed. This integration is part of the default HACS store (though can also be added manually using repository: rsnodgrass/hass-gocoax)
The goCoax MoCA unit IP address must be accessible from the Home Assistant host. Either set a static IP on the goCoax admin panel or use static DHCP assignment.
Add via the Home Assistant UI: Settings > Devices & Services > Add Integration > goCoax
- Host: IP address of your goCoax adapter
- Username: Admin username (default:
admin) - Password: Admin password (default:
gocoax)
| Sensor | Description |
|---|---|
| Link Status | MoCA network connectivity (on = connected) |
| Network Controller | Whether this adapter is the MoCA Network Controller |
| Encryption Enabled | MoCA privacy/encryption status |
| Sensor | Description |
|---|---|
| MoCA Version | Protocol version (2.0, 2.5) |
| MAC Address | Adapter's unique MAC address |
| IP Address | Adapter's IP address |
| Node ID | MoCA network node identifier |
| Network Peers | Count of other adapters on the MoCA network |
| TX Packets | Ethernet transmit packet count (with ok/bad/dropped attributes) |
| RX Packets | Ethernet receive packet count (with ok/bad/dropped attributes) |
| PHY TX Rate | Physical layer transmit rate to each peer (Mbps) |
| PHY RX Rate | Physical layer receive rate from each peer (Mbps) |
| Frequency Band | Operating frequency band (D-Low, D-High, Extended-D) |
| Lowest Operating Frequency | LOF in MHz |
| Channel Count | Number of bonded MoCA channels |
The following information is shown in the device details:
- Model name
- Firmware version
- Configuration URL (link to adapter web UI)
After initial setup, you can configure:
- Update Interval: How often to poll the adapter (10-300 seconds, default: 30)
The following features are planned for future releases:
- Device Tracker: Track devices on the MoCA network by MAC address
- Configuration Options: Band selection, encryption toggle (pending API write support)
- SNR/Power Level Sensors: Signal-to-noise ratio and power levels (pending endpoint discovery)
Contributions are welcome! If you have a goCoax adapter and want to help improve the integration:
- Enable debug logging to capture raw API responses
- Share endpoint data (with MAC addresses redacted) to help improve parsing
- Report issues or submit pull requests on GitHub
logger:
logs:
custom_components.gocoax: debugThis integration is maintained in my free time. Sponsorship directly funds new device support and faster updates.