TouchColorPiggy

Code for the Waveshare ESP32-S3-Touch-LCD-2 based LightningPiggy

See:

• https://www.waveshare.com/product/arduino/boards-kits/esp32/esp32-s3-touch-lcd-2.htm
• http://www.waveshare.com/wiki/ESP32-S3-Touch-LCD-2

Installation

• Copy the "libraries" contents into your ~/Arduino/libraries folder
• Open with Arduino IDE (tested with 2.3.5)
• Install arduino-esp32 support (tested with 3.2.0)
• Select "Tools" - "Board" - "ESP32" - "Waveshare ESP32-S3-Touch-LCD-2.1"
  • Tools -> CPU Frequency: 240Mhz
  • Tools -> Flash Mode: QIO 80Mhz
  • Tools -> Flash Frequency: 80Mhz
  • Tools -> Upload Speed: 921600
  • Tools -> Partition Scheme: 16MB flash
  • Tools -> Core Debug Level: Debug
  • Tools -> PSRAM: Enabled
  • Tools -> Port: /dev/ttyACM0
  • Tools -> USB Firmware MSC On Boot: Disabled
  • Tools -> Upload Mode: USB-OTG CDC (TinyUSB)
  • Tools -> USB Mode: Hardware CDC & JTAG