Replies: 3 comments 1 reply
-
This indicates the ethernet network interface's state of your Raspberry Pi has been continuously changing. You may use |
Beta Was this translation helpful? Give feedback.
-
|
On the other hand, have you let your otbr-agent join/create a Thread network? I don't see relevant logs. |
Beta Was this translation helpful? Give feedback.
-
|
ip monitor link command doesn't seem to show anything for what happened. The previous behavior happens if i didn't join/create thread network in a little time (less than 3 minutes) which is strange for me ! I wants to run test cases from thread harness tool under br1 and br2 roles so I needed to add thread border router and start running test case quickly before otbr-agent stop running. Although I have managed to start previous procedure quickly, I can see many test cases fails from test harness 1- Is the behavior of restarting otbr-agent normal in case of no activity done on the device ? 2- Are there any specific configurations that should be enabled in raspberry pi setup to run BR_1 and BR_2 roles for thread 1.2 test cases like DUA feature ( is it enough to use default build INFRA_IF_NAME=eth0 ./script/setup) ? |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
Hi,
I'm working on OTBR using raspberry pi (RCP design),
I have followed steps from : https://openthread.io/guides/border-router/build#install-otbr
raspberry pi and my pc are connected on locally ethernet switch( not connected to internet) , pc communicate with raspberry pi using ssh.
otbr-agent keep changing status continuously and when it's status not running, I can't communicate to raspberry pi.
The following logs shows the services status
can anyone help me with this ?
Thanks
Beta Was this translation helpful? Give feedback.
All reactions