WEG Causes Boot Hang in macOS Tahoe Installer (Auqa Session issue), Works After Installation

[laobamac]

On macOS Tahoe, WhateverGreen fails to bring up the graphical interface during the boot installer, getting stuck on the message 'KextLog: Collection UUID matches with loaded KCs.' Disabling WEG and completing the installation allows normal system entry after re-enabling WEG. This issue has occurred from Beta1 to PublicBeta1.

OpenCore：1.0.6 Dev
PC：13900KS_ROG Z790-H_RX570 (Use PVE 8.2 and RealPC)
System: macOS Tahoe PB1 26.0
Screenshot：

Note:At this time, it has entered the system, but the graphic pull-up failed. If the -v parameter is disabled, the mouse can already be seen.

Note:After disabling WEG, you can enter the installer and recovery mode at any time. Turn on the WEG card in the above position. Entering the installed system, you can turn on WEG normally (if you don't turn it on, you will lose the high refresh rate and HIDPI).

Best regards.

[Andrey1970AppleLife]

Also this bug is confirmed by users AppleLife.ru
CC @vit9696

[Andrey1970AppleLife]

There is a message that on a beta 6 issue is absent. https://www.applelife.ru/posts/1067702
Somebody else can confirm?

[laobamac]

There is a message that on a beta 6 issue is absent. https://www.applelife.ru/posts/1067702 Somebody else can confirm?

Well,I have OTAed from PB1 -> B6.But WEG still stuck at KextLog-------- when installing.Only works well after installing.

[laobamac]

acidanthera/WhateverGreen#126

See this.