Bypassmode in min Soc

[Zanooon97]

Hi @dav1dBoy do you know how to activate the bypass mode in low soc condizions?
For example my battery is 15% and solar power should bypassed directy in the house and the rest of missing energy by the grid.

In the data read propertys is the Pass entity. How can I activate this manually?
Is there a way
Because HEMS is setting the bypassmode in the morning when there is not enough energy to fit the house, only when there is enough energy to charge the battery its charging.
So i can eliminate the charge an dischargin cycles in my devices.

Best regeards

[dav1dBoy]

Hi @dav1dBoy do you know how to activate the bypass mode in low soc condizions? For example my battery is 15% and solar power should bypassed directy in the house and the rest of missing energy by the grid.

In the data read propertys is the Pass entity. How can I activate this manually? Is there a way Because HEMS is setting the bypassmode in the morning when there is not enough energy to fit the house, only when there is enough energy to charge the battery its charging. So i can eliminate the charge an dischargin cycles in my devices.

Best regeards

Hi ！
If your goal is to reduce the battery charge/discharge cycles and keep the battery in a healthier state, you can achieve this by configuring the charge and discharge limits rather than manually enabling a bypass mode.

Based on your scenario:
• For example, if you set the SF800 output to 800 W and your solar input is 800 W, then all solar power will be used directly by your home.
• If the solar input is 900 W, the extra 100 W will automatically go to the battery.
• However, in the morning, when solar production is low, you can configure a charge stop limit, e.g. 70%, so the system avoids unnecessary charging and discharging at low SOC.

Please note that “bypass mode” here refers to a system status, not a user-configurable mode. It’s automatically handled by the energy management logic and cannot be manually switched on/off.

Best regards,
David