Start a print for different paper sizes allways at the same corner and place

[Werner2]

I would like if I could define X0, Y0 at the top right of a paper (A4 , A3 or A2) and start the print allways at the same position. The exported Gcode from Makelanglo should work with this position for X0 and Y0.
I would only have to place the tip of the pen at this corner and start the print. This allowes also an easy adjustment when I use different pen sizes in the same picture

This would be a similar procedure that works on my plotter with endstopps disembled when I delete the G28 X Y command in the Find home Gcode in custom Gcode settings and add G92 X0 Y0 Z0 in custom Gcode. The Z0 is for the Z-stepper in the upper position of the gondola. Actually I have to place the gondola in the middle of the paper.

[i-make-robots]

Would it be good enough to have 5 checkboxes - one for each corner and one in the middle?

[Werner2]

I think that would be o.k.