OnlyT 2.2.0.1

[AntonyCorbett]

Support for NDI® output. Please treat this pre-release as experimental!

To enable NDI support, please run OnlyT with --ndi on the command-line. When enabled, the Timer window is not visible; rather the output is available as an NDI source. If this release is successful, I will also make the countdown timer optionally available as a separate NDI source.

Note that NDI® is a registered trademark of Vizrt Group, Inc.

Note that this release is 64-bit only (whereas the previous release was 32-bit). This release will appear as a different installation of OnlyT but will share settings with any 32-bit installation you may have.

---

This discussion was created from the release OnlyT 2.2.0.1.

[KovalevArtem]

Please add NDI support for Meeting Countdown 🙏